Industrial Hardware WD-40 Fast Drying Contact Cleaner

home > Products> Industrial Hardware> WD-40 Fast Drying Contact Cleaner

WD-40 Fast Drying Contact Cleaner

Dielectric strength up to 35,000 Volts per 0.1 inch
Fast acting, non-conductive cleaner
Penetrates quickly, fast drying and leaves no residue
RoHS compliance
Perfect for cleaning electrical equipment, contacts and plastics

Product Description

APPLICATION
Circuit Boards / Controls / Electrical Assemblies / Printers and Copiers / Switches / Tape Heads and Precision Instruments
*It is advisable to test on a sample before use. For all precision instruments, check with manufacturer. Prolonged exposure for rubber not recommended.

DIRECTIONS

Isolate all electricity and allow hot surfaces to cool. Make sure all stored power is drained from the system. Shake can well before use
Hold can 15cm to 20cm away from the surface and spray directly onto the electronic device or circuit board to eliminate and remove contaminants that may cause loss of electrical contact
Tilt surface while cleaning and allow any excess cleaner to run off
Allow product to dry completely and thoroughly vent the system before restoring power

Frequently Purchase Together

BOSCH GWS060 Grinding Machine

Rated power input: 670 W
No-load speed: 12,000 rpm
Grinding spindle thread: M10
Disc diameter: 100 mm
Length: 263 mm
Width: 77 mm
Weight: 1.5 kg (without cables and accessories)

JETECH Voltage Tester VT-140

Use Range: test electrical circuits, outlets, and wiring in residential, commercial, and industrial.
Material: Durable insulated plastic body with a shock-resistant design.
Ergonomic, non-slip handle for a secure grip during testing.
Precision metal tip for accurate contact with electrical components.